Modern solid state electronic regulator for models with Bosch charging system

Bolts to original mounting point but this replacement part is not as tall as the old metal regulator. Also known as Guzzi ref. 17703800. Replaces ELA29704

See our Bosch fault finder page for help diagnosing problems on your Bosch charging system. The original type mechanical regulator is no loger available

 2 in stock

29703800-z 29703800 GU29703800 29 70 38 00
 2970 3800 2970.3800 29.70.38.00

Oil temperature sensor

See ELA03330 for sensor support

 1 in stock

 29724961 GU29724961 29 72 49 61
 2972 4961 2972.4961 29.72.49.61

NGK iridium MR8BI-8 spark plug

 2 in stock

1A010638

Also fits Aprilia DORSODURO 900 J ABS (2018-202), Aprilia SHIVER 900 (2017-2020), Piaggio LIBERTY 50 3V I-GET (2017-2018), Vespa PRIMAVERA 50 4T 3V N (2022), Vespa PRIMAVERA 50 4T 3V N (2022), Vespa SPRINT 50 4T (2018), Vespa SPRINT 50 4T 3V N S (2022)

Fuel level sender for fuel tank

2 pin connector block

 This part is available by special order, request a quote

 30103000 GU30103000 30 10 30 00
 3010 3000 3010.3000 30.10.30.00

Pair of ignition points (made up of Guzzi part numbers 14715429 and 14715430)

 3 in stock

 14719800 GU14719800 14 71 98 00
 1471 9800 1471.9800 14.71.98.00

Universal hydraulic brake light switch. This hydraulic switch replaces discontinued brakelight switches by bolting in place of a single banjo bolt on the handlebar or rear brake master cylinder

NB stop light switch may be supplied with or without 2 pin block connector. Can be used in place of Guzzi ref. 32657060

 1 in stock

Fuel level sender for fuel tank

2 pin connector block. Use seal TAA90103 with this part

 This part is due back in stock soon, call 01484 841395 to reserve yours

29103050-z 29103050 GU29103050 29 10 30 50
 2910 3050 2910.3050 29.10.30.50

Oil pressure switch M10 thread

Supercedes Guzzi no. 1A014570

 This part is due back in stock soon, call 01484 841395 to reserve yours

1A017929

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

Sidestand cutout switch

See ELA81319 for rotary switch that was fitted to some models

 This part is available by special order, request a quote

 639542 MG639542